MIL-HDBK-1001-5 Roofing And Waterproofing S/S By Mil-Std-3007This handbook sets forth guidelines for design of roofing, LAYOUT 1 and waterproofing systems for building construction. It covers design of new low-slope and steep roof systems, reroofing of existing buildings, and waterproofing, and dampproofing systems.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84 - 85 - 86 - 87 - 88 - 89 - 90 - 91 - 92 - 93

MIL-HDBK-1001/5A

with insulation board.  Extruded polystyrene is excellent for this purpose.

Preformed membranes: This class is factory-produced, consisting of a film of paper, polyethylene, polyvinyl chloride, etc., and coated on both sides with rubberized asphalt or coal tar pitch.  Specify membrane manufacturer's recommended primer and adhesives.

13.5      Dampproofing.  Many installations do not require an absolute waterproofed surface but only retarding of moisture penetration.  This retardation can be accomplished with brushable or trowelable bituminous or synthetic materials hot- or cold- applied.  All such materials require the appropriate primer when applied over masonry.  At least two coats of dampproofing

material are usually required.

13.6      Applicable Details.  Refer to NRCA Roofing and

Waterproofing Manual.

53